Services
CFD simulation services for focused product and system decisions
Each service module is scoped around the engineering question, the available data and the deliverables needed to make the next design decision.
Airflow & Pressure Drop CFD
Problem
High pressure loss, uneven flow distribution or uncertain inlet and outlet behavior.
What we simulate
Internal airflow, pressure drop prediction, flow uniformity, inlet/outlet optimization.
Deliverables
Pressure loss summary, velocity and pressure fields, restriction locations and design recommendations.
Typical inputs needed
CAD files, flow rate or pressure targets, fluid type, operating range and fixed design constraints.
Thermal Management CFD
Problem
Components are overheating or cooling layout decisions need evidence before prototyping.
What we simulate
Electronics cooling, battery thermal behavior, heat sink and fan airflow, enclosure ventilation.
Deliverables
Temperature maps, airflow paths, hot spot review, fan/vent comparison and report.
Typical inputs needed
Heat loads, material data, ambient conditions, fan curves, CAD and component limits.
Aerodynamics CFD
Problem
External airflow changes may affect drag, downforce, stability or cooling.
What we simulate
Drag reduction, downforce analysis, spoiler and diffuser evaluation, external vehicle airflow.
Deliverables
Force trends, pressure distribution, streamlines, wake review and concept comparison.
Typical inputs needed
Vehicle or component CAD, speed range, ride height, moving ground needs and comparison geometry.
Vape / Atomizer CFD
Problem
Draw resistance, air path layout or heating-zone flow needs improvement.
What we simulate
Air path optimization, draw resistance prediction, aerosol transport support, condensation risk indicators and heating zone airflow.
Deliverables
Pressure drop trend, velocity distribution, recirculation regions and optimization notes.
Typical inputs needed
Device CAD, target draw flow or pressure, air inlet/outlet locations and parts that cannot change.
UAV / Drone CFD
Problem
Flight endurance, drag, cooling airflow or packaging changes need aerodynamic review.
What we simulate
Airframe drag analysis, propeller interaction support, cooling airflow and endurance-oriented optimization.
Deliverables
Drag comparison, pressure map, flow separation review and cooling path assessment.
Typical inputs needed
Airframe CAD, speed range, attitude, payload state, heat sources and propeller assumptions.
HVAC / Ventilation CFD
Problem
Airflow comfort, temperature distribution or ventilation effectiveness is uncertain.
What we simulate
Indoor airflow, temperature distribution, air quality and ventilation effectiveness, data center cooling.
Deliverables
Velocity and temperature fields, airflow path review, comfort indicators and layout suggestions.
Typical inputs needed
Room geometry, diffuser locations, flow rates, heat loads, occupancy assumptions and target criteria.
Ready to validate or improve your design with CFD?
Send your geometry, operating conditions and target metrics. We will review the project scope and respond with practical next steps.